Setting up Netezza Connections

You can set up a connection to a Netezza (IBM PureData for Analytics) appliance here. Simply populate the requested data into the form.

mceclip0.png

Note
Netezza does not allow us to distribute their drivers so you must obtain
it from your DBA or directly from IBM Fix Central.

Using SSL with Netezza Connections

Aginity Team supports SSL when setting up a Netezza connection. While setting up your Netezza connection simply select the level of security to enable from the dropdown selector. Your choices include:

  • Only Unsecured - Specify this option when you want an unsecured connection to the Netezza system. If the Netezza system requires a secure connection, the connection is rejected.

  • Preferred Unsecured - This argument is the default value. Specify this option when you would prefer an unsecured connection, but you accept a secured connection if the Netezza system requires one.

  • Preferred Secured - Specify this option when you want a secured connection to the Netezza system, but you accept an unsecured connection if the Netezza system is configured to use only unsecured connections.

  • Only Secured- Specify this option when you want a secured connection to the Netezza system. If the Netezza system accepts only unsecured connections, or if you are attempting to connect to a Netezza system that is running a release before release 4.5, the connection is rejected.

     

See also
For more information on SSL refer to the link Netezza SSL

Connection Timeout

The connection timeout will tell the session when to disconnect. Typically set this to 10 minutes or 3600 seconds.

Advanced Parameters

For Netezza you can supply additional JDBC parameters using the Advanced Properties section.

See also
Here is the link to other configurable parameters supported within Netezza JDBC’s driver
 
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request